Installation
Before using this product, read instruction manual and all warnings thoroughly.
FOLDING YOUR COVER
Removal is the reversal of installation. Start by loosening the cover at the front and rear of the vehicle. Lift each side of the cover on to the roof of the vehicle, folding the cover onto itself until the width is approximately 18” as shown. Starting from the front of the vehicle, roll the cover up as tightly as possible and store your cover in storage bag.
CARE/WASHING INSTRUCTIONS
Surface dirt and dust can be removes from your car cover by using the method outlined below. NOTE: This cover can not be placed in a commercial washer for cleaning.
Hand Wash:
1.The car cover can be hand washed either on or off the vehicle.
2.Do NOT use detergent or Wash Machine. Use cold water with soft sponge, clean lightly the soiled area and allow the cover to air dry in place.
3.Wash contaminated area with a soft clean brush. Rinse area immediately with COLD water and allow cover to dry.
Hosing Off:
A simple cleaning method to remove dust, etc. is to hose off the cover while on the car. Turn the cover inside out and install on vehicle to clean dust from the underside of cover. Allow to air dry.
Warning:
- Never place the car cover on the vehicle when the engine or hood are hot. Allow time to cool prior to installation.
- DO NOT use on a vehicle that has been recently repainted. It may cause damage to your paint job. Please consult body shop for exact curing time used on your vehicle.
- Never place the car cover on a wet vehicle.
- Never cover a hot tailpipe.
- DO NOT place sharp on the cover as this may damage the fabric.
- DO NOT use on a convertible with the top down or a vehicle with open sunroof or T-tops.
- NEVER use a car cover while trailering a vehicle.
- ALWAYS tie down the cat cover using the grommets during high winds.
- In the case of inclement weather, allow ice or frozen precipitation to thaw prior to removing the car cover. (In extreme cases, a thin layer of ice may form between you vehicle and this car cover) You may use warm water to speed the thawing process and gently lift the cover off the vehicle as not to damage paint.
- Make sure to completely remove the cover every week. Clean the surface of car body and your cover before putting back the cover onto the car.
THEFT DETERRENT
Optional Cable & Lock to protect your cover investment. Some cover may include grommets where you can tie and lock the cover with cable & lock.
We suggest that you stencil or print your vehicle’s license plate number prominently on your new car cover. Some states require that the license number of a covered vehicle be clearly displayed.